Week 2 of the 2019 American Patchwork & Quilting Quilt-Along starts on 2/25. The assignment is: Cut 1-1⁄2"-wide strips. Below you'll find some helpful tips for cutting fabrics for this quilt, and some answers to questions we've been getting. See more about the Quilt-Along here.
Each product we feature has been independently selected and reviewed by our editorial team. If you make a purchase using the links included, we may earn commission.

First things first. What should I do before I even start cutting?

Change your rotary cutter blade if you haven't done that recently. That will make the cutting process much easier. Clean off your cutting surface and have a bin handy for the trimmings. Make sure your ironing board and iron are clean. Iron cleaning products are available at your local quilt shop or chain store. If you need something right now, try this simple solution. Wipe off the iron with a damp cloth to remove dirt and dust. Remove as much as you can from the soleplate. Turn the iron on hot. Grab an old towel and rub the ironing surface over it until all the buildup is removed. When the iron cools off, wipe it again with a clean cloth. The soleplate will be as good as new!

How do I prep my fabric for cutting?

Iron your fabrics using the right heat setting for the type of fabrics you're using (consult your manual if you're not sure). You can use steam or no steam -- it's up to you! Iron your fabrics flat (mist with water if you have a stubborn crease), then lay flat to cool. You can also choose to use starch to keep fabrics crisp while cutting.

How do I protect my back and wrists while cutting this many strips?

Bending at the hip rather than at the waist when rotary-cutting is easier and puts less stress on your back and arms. To facilitate this, place your cutting mat on an appropriate-height table or countertop. Consider getting an ergonomic rotary cutter if you experience wrist pain. And remember, take frequent breaks to stretch and rest.

There are a lot of strips in this quilt -- what's an easier way to cut this many?

Reduce the time it takes to cut strips with the AccuQuilt GO! Fabric Cutter and 1-1⁄2"-wide strip die (55024). It can precisely cut up to six layers of fabric at a time. For more info, visit: AccuQuilt.com. If you're using a rotary cutter, you can cut up to four layers of fabric at a time (if you do this, make sure you have a new rotary cutter blade and are getting accurate cuts).

When I'm cutting, my ruler shifts making my strips slightly larger/smaller on one end. How do I improve my accuracy?

If your ruler is shifting (this can happen when you're cutting longer strips, usually at the top of your cut), there are a few things to try.

1. Slow down. Stop cutting half way, reposition your hand closer to the top of the ruler for a more secure grip, then finish cutting the strip.

2. Try using a ruler grip or non-slip adhesive on the back of your ruler.

3. If your fabric seems to be shifting, try starching it to keep it crisp and flat for easy cutting.

How do I keep track of all these strips?

When you're cutting, place them in piles of a certain number (10 strips, 25 strips, etc). Then you can see at a glance how many you have. If you're losing count, use a small post-in note or piece of paper to write down the number of strips, then pin it to the top of the pile. Keep your lights and mediums/darks separated, so you don't accidentally sew the wrong strips together in the next steps.